Bnc 1201 - 6 1/2 Digit Digital Multimeter Manuel d'utilisateur télécharger pdf (Page 78)

※ Note: Press RATIO button, the “RATIO” anunnciator will be lit on the

display.

4.3.1 Ratio

This function calculates the ratio of an input DC voltage to a reference DC

voltage according to the following equation:

How to make a ratio measurement

There are two ways to make a ratio measurement: Through the front

panel operation or through the remote interface operation.

Front Panel Operation

Use TERMINALS button to select the front terminals or the rear terminals.

Press CONFIG + RATIO, and then use ◁ and ▷ buttons to locate

“RESOLUTION” option (Refer to 4.1.3) and “FILTER” option (Refer to

4.1.2.2). Press ENTER to make choices. Then select desired value for it

by pressing ◁, ▷, △ and ▽ button. Press ENTER to choose it. For

operating this function, please press RATIO button and observe the

reading on the display as shown as Figure 4-14.

※ Note: To close this function, please press one of the measurement

function buttons.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 176 177

Pas de commentaire

Bnc 1201 - 6 1/2 Digit Digital Multimeter Manuel d'utilisateur Page 78