Bnc 1105 Universal Counter Manuel d'utilisateur télécharger pdf (Page 26)

2626

To measure period

1. Connect your signal source to channel 1.

2. Press TIME&PERIOD button.

3. Press the softkey under Period to select period measurement

function.

4. Optional settings:

a. Use GATE&ExtArm button to set the gate time, resolution or arming

if needed (refer to Ch.4.3).

b. Use Scale&Offset button to set the scaling and offset parameters if

needed (refer to Ch.4.4).

c. Use Limit Modes button set the upper and lower limits if needed

(refer to Ch.4.5).

d. Use Stats button to set up the statistics function and limit filtering if

needed (refer to Ch.4.6).

e. Use the selections in the CH1 to set the input conditions and the trig

Sens.

f. Use Show Status button to check the conditions of Input, Volt, Stats

and Limit.

g. Use Save&Recall button to save your settings (i.e., changes made in

steps a-d) if needed (refer to Ch.4.9).

5. Press RUN button to make continuous measuremets.

6. Press STOP/SINGLE button to make single measurement or to stop

continuous measurements.

Remote Interface Command

Use the following commands for making period measurement:

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]PERiod [1|2|3]”

:CONFigure[:SCALar][:VOLTage]:PERiod [(@1)|(@2)|(@3)]

:READ[[:SCALar][:VOLTage]:PERiod]?

:MEASure[:SCALar][:VOLTage]:PERiod? [(@1)|(@2)|(@3)]

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 196 197

Pas de commentaire

Bnc 1105 Universal Counter Manuel d'utilisateur Page 26