Bnc 1105 Universal Counter Manuel d'utilisateur télécharger pdf (Page 115)

115

115115

115

digits range from 1 to 15, depending on the resolution.

Notes



The statistics operation should be enabled (:CALC3:AVER[:STATe] ON ) before using

this command. If not, Not A Number 9.91E37 will be returned and error -221 will be

generated.



The result is separated by commas, and the display order is mean value, standard

deviation, minimum value and then maximum value.



If there is no valid result, Not A Number 9.91E37 will be returned and error -230 will

be generated.



If the current measurement operation is Totalize or Voltage Peaks, Not A Number

9.91E37 will be returned and error -221 will be generated.

:CALCulate3:AVERage:CLEar

Clears the statistics data, sets the statistics counts to zero and reports the negative

status condition to bit 8 of the Operation Status Register.

Notes



If the statistics operation is not enabled (:CALC3:AVER[:STATe] OFF, error -221 will

be generated.

:CALCulate3:AVERage:COUNt <numeric value>

Sets or queries the number of measurement that to be used in the statistics operation.

The range of this number is from 2 to 1,000,000.

Return



Numeric data transferred as ASCII bytes in <NR1> format.

Notes



This will be set to the counter’s default, 100, after the counter has been turned off or

a remote interface reset.



When the specified number of measurement has been collected, another set of

measurements has to be collected before the counter does another statistics

calculation.

:CALCulate3:AVERage:COUNt:CURRent?

Queries the number of measurement collected so far for statistics calculation. The range

is from 0 to 1,000,000.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 196 197

Pas de commentaire

Bnc 1105 Universal Counter Manuel d'utilisateur Page 115