Bnc 835 Programmer Manual Manuel d'utilisateur télécharger pdf (Page 46)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901

Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com

5.13 [SOURce]:AM Subsystem (Amplitude Modulation)

Command

Parameters

Unit (default)

[SOURce]:AM:DEPTh

<value>

0.8 (80 PCT)

[SOURce]:AM:STATe

ON|OFF|1|0

[SOURce]:AM:INTernal:FREQuency

<value>

400 Hz

[SOURce]:AM:SOURce

INTernal | EXTernal

:AM:DEPTh

[SOURce]:AM[:DEPTh]: <value>

[SOURce]:AM[:DEPTh]:?

This command sets the amplitude modulation depth 0...1.

*RST 0.8

Range 0-0.99

:AM:INT:FREQuency

[SOURce]:AM:INTernal:FREQuency <value><unit>|UP|DOWN

[SOURce]:AM:INTernal:FREQuency?

This command sets the internal amplitude modulation rate.

*RST 400 Hz

Range 10 Hz to 50’000 Hz

The RF carrier is modulated when you have set the signal generator’s AM modulation state to ON.

Whenever amplitude modulation is enabled, the AM on is in the display.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 64 65

Pas de commentaire

Bnc 835 Programmer Manual Manuel d'utilisateur Page 46