Bnc 835-3 Programmer Manual Manuel d'utilisateur télécharger pdf (Page 25)

Berkeley Nucleonics

www.Berkeley Nucleonics.com

835-3

Programmer’s Manual v1.0

Page 25 of 37

:LFOutput:AMPLitude

[SOURce]:LFOutput:AMPLitude <value>

[SOURce]:LFOutput:AMPLitude?

This command sets the low frequency generator amplitude. This setting does only take

effect if :LFOutput:SOURce is set to LFGenerator and LFOutput:SHAPe is either set to

SINE or TRIangle. Using any other setting, the output amplitude is fixed 2.5 V.

The variable <value> is expressed in units of Volt.

Range 0-2.5

*RST 1

:LFOutput:FREQuency

[SOURce]:LFOutput:FREQuency <value>

[SOURce]:LFOutput:FREQuency?

This command sets the low frequency generator frequency. This setting does only take

effect if :LFOutput:SOURce is set to LFGenerator.

The variable <value> is expressed in units of Hertz.

Range 10-5000000

*RST 400

:LFOutput:STATe

[SOURce]:LFOutput:STATe ON|OFF|1|0

[SOURce]:LFOutput:STATe?

This command sets the function output / low frequency generator state.

*RST OFF

:LFOutput:SHAPe

[SOURce]:LFOutput:SHAPe SINE|TRIangle|SQUare

[SOURce]:LFOutput:SHAPe?

This command sets the low frequency generator waveform. This setting does only take

effect if :LFOutput:SOURce is set to LFGenerator.

SINE Sine wave output, amplitude is selectable by the :LFOutput:AMPLitude

setting.

TRIangle Triangle wave output, amplitude is selectable by the :LFOutput:AMPLitude

setting.

SQUare Square wave output, amplitude is fixed 2.5 V.

*RST SINE

:LFOutput:SOURce

[SOURce]:LFOutput:SOURce LFGenerator|PULM|TRIGger

[SOURce]:LFOutput:SOURce?

This command sets the low frequency generator waveform. This setting does only take

effect if :LFOutput:SOURce is set to LFGenerator.

LFGenerator This selects the low frequency generator as the function output signal.

PULM This selects the pulse modulation video out as the function output signal.

TRIGger This selects the trigger as the function output signal.

*RST LFG

[SOURce]:SWEep Subsystem

Command Parameters

Unit

(default)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Bnc 835-3 Programmer Manual Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Bnc 835-3 Programmer Manual